Reverse engineering an e-scooter and rewriting the firmware in Rust

T1Covered by 1 source · first reported by Raspberry Pi / Arduino / Adafruit at 28 Sept, 19:46 UTC

Ben took apart an Egret GT e-scooter and replaced the display firmware with their own code written in Rust. The USB-C port on the display, advertised for charging phones, turned out to carry a CAN bus on two of its pins. A sniffer built from an ESP32-C6, an SN65HVD230 and an MCP2515 logged the…

dev

Sources

• T1Reverse engineering an e-scooter and rewriting the firmware in RustRaspberry Pi / Arduino / Adafruit28 Sept, 19:46