Print-in-Place Egg Slicer – Zero Supports, Zero Rafts #3DThursday #3DPrinting

T1Covered by 1 source · first reported by Raspberry Pi / Arduino / Adafruit at 06 Nov, 00:01 UTC

Shared by RS_666 on Maker World: A print-in-place egg slicer — cuts egg into slices. No rafts, no supports. 0.2mm layer, 4 walls, 50% infill. ~1.9h, 1 plate. 4.7★ from 45 ratings. CC BY-NC-SA 4.0. Alt kitchen helper — not scheduled in main this week to avoid double-up with the Egg Carrier (9AM)…

telecom

Sources

• T1Print-in-Place Egg Slicer – Zero Supports, Zero Rafts #3DThursday #3DPrintingRaspberry Pi / Arduino / Adafruit06 Nov, 00:01